

Sopoby Solder Seal Wire Connectors
SPECIFICATION
·Shrinkage ratio 2:1
·Dual-walled design tubing: polyolefin tubing on the outside and hot melt adhesive inside Color coded connector tubing Heat activated waterproof adhesive
·Temperature that start to shrink: 80℃
·Temperature that solder ring start to melt: 111℃
·Temperature that solder ring melt completely:138℃
Note: We suggest the temperature that the hot air gun should set about:400-600 ℃ (752-1112 ° F)
· Rugged and puncture resistant.
· Waterproof.
· Resistant to abrasion, stretch and vibration
· Heat activated adhesive
· Greater tensile strength
· All materials are heat resistant
· Suggest used a 1500W heat gun.

·Create a waterproof seal
·Resistant to stretch and vibration
·Color coded for easy identification

·Starts to melt at lower temperature (280°F)
·Prevents burns in the heat shrink tubing
·A more efficient alternative to soldering

·Offer protection to the wires and cables from abrasion, cutting, scuffing and low impact situations.
·Create cable entry seals, offering environmental sealing protection.

Strip wire insulator with a proper length and insert wires into the solder sleeve of proper size

Twist the conductor together and move the connector to the middle of the conductor

Evenly heat by a heat gun (better with reflector nozzle) until it melts
WIDE APPLICATIONS

MOTORCYCLE

LIGHT

DIY