Custom 3D Printed dial that makes it easier and quicker to dial in your Axcel Driver. 1.85" outer diameter. NO gluing and NO screws digging into existing metal dial but still offers a secure attachment. Embedded stainless steel nut for durability. Requires 1/16" hex key for installation (not included). Printed with UV resistant ASA material which can withstand higher temps than most normal 3D prints made from PLA or PETG. If you would like a different color than what is currently available send me a message and we can potentially work something out.

If you would like a split color ring, also send me a message.

Feedback is greatly appreciated.

Installation Instructions:

1. Remove existing rubber ring from bow sight.

2. Remove screws from new ring.

3. Slide two halves over existing dial ring from each side, taking care to keep from bending small internal tabs on 3D printed ring. Do not force on from the front.

4. Insert and tighten screws until the two halves snug up, do not over tighten.

5. Rotating sight dial can make accessing second screw easier.

6. Not recommended to store in a hot car in direct sunlight.

7. Trying to force dial when sight is locked could lead to failure.